Garbage disposal humming or dead? Find the garbage disposal reset button, clear a jam with a 1/4-inch hex key, and fix it in minutes without a plumber.
This guide walks you through finding it, clearing the jam that usually causes it to trip, and knowing when it really is time to call for help. Most people are done in under ten minutes, and the only tool you might need is a $5 hex key.
Quick answer: Turn the disposal off, wait 10 to 15 minutes for the motor to cool, then press the red reset button on the bottom of the unit until it clicks and stays in. If it hums but won’t spin, free the jam with a 1/4-inch hex key in the center hole underneath, then reset again.
Why Your Garbage Disposal Reset Button Pops Out
Every disposal has a built-in overload protector. When the motor works too hard or gets too hot, the protector cuts the power and the reset button pops out. It’s a safety feature, not a breakdown.
The most common reasons it trips:
- A jam. A fruit pit, bottle cap, bone or piece of silverware gets wedged between the spinning plate and the grinding ring.
- Too much at once. Shoving a whole plate of scraps in at one time overloads the motor.
- Tough or stringy food. Celery, corn husks, onion skins and potato peels wrap around parts or pack into a paste.
- Running it without water. Cold water keeps things moving and helps the motor stay cool.
What the sound tells you
| What you hear | What it usually means |
|---|---|
| Nothing at all | The overload tripped, or the power is off at the breaker, outlet or switch |
| A steady hum | The motor has power, but something is jammed and the plate can’t turn |
| Grinding metal or rattling | Something hard is loose inside the chamber |
How to Find and Press the Garbage Disposal Reset Button
Step 1: Turn off the power
Flip the wall switch off. If your disposal plugs into an outlet under the sink, unplug it too. Never put your hand inside the disposal, even with the power off.
Step 2: Let the motor cool
If the disposal was running when it quit, give it 10 to 15 minutes. A hot motor will just trip the protector again.
Step 3: Locate the garbage disposal reset button
Grab a flashlight and look at the bottom of the unit under the sink. On most models the garbage disposal reset button is small, round and red, about the size of a pencil eraser. On some models it sits low on the side instead.
Step 4: Press it until it clicks
Push the button firmly. A tripped button sticks out a little and should click and stay in. If it was already flush, the overload probably didn’t trip, so skip ahead to the jam and power checks below.
Step 5: Test it
Plug it back in, run cold water, and flip the switch. If it grinds normally, you’re done.
When the Garbage Disposal Reset Button Isn’t Enough: Clear the Jam
If the disposal hums but won’t spin, or the reset button pops right back out, something is stuck. Here’s the fix most people don’t know about.
Use a 1/4-inch hex key from below
Look at the very center of the bottom of the disposal. There’s a small six-sided hole. Many disposals came with a little crank-shaped wrench for it (check the junk drawer or the side of the unit, where it’s sometimes taped). A standard 1/4-inch Allen wrench works just as well.
- Make sure the power is off and the unit is unplugged.
- Push the hex key into the center hole.
- Work it back and forth. It’ll feel stiff at first, then loosen as the jam breaks free.
- Keep going until it turns a full circle easily.
- Remove the wrench.
Pull out what caused it
Shine a flashlight down the sink drain. If you see the object that caused the jam, pull it out with tongs or needle-nose pliers, never your fingers. Then press the reset button again, restore power, run cold water and test.
Don’t Forget the Simple Power Checks
If the disposal is completely silent and the reset button didn’t help, the problem may not be the disposal at all.
- Check the breaker. Look for a tripped breaker in your electrical panel and flip it fully off, then back on.
- Check the GFCI outlet. Kitchen outlets often have Test/Reset buttons, and one may control the disposal outlet. Press Reset.
- Check the plug. Under-sink plugs get bumped loose when people grab cleaning supplies.
When to Call a Pro (or Replace It)
The reset trick and the hex key solve most problems, but not all of them. Call a plumber or electrician if:
- The reset button keeps popping out even after the plate turns freely
- The hex key turns easily but the disposal still only hums
- You see water leaking from the bottom of the unit
- You smell burning or see scorch marks
Those usually point to a worn motor or a leak inside the housing. Disposals don’t last forever, so an older unit with these symptoms is often cheaper to replace than repair.
Quick Checklist: Garbage Disposal Not Working
- ☐ Switch off, unplugged
- ☐ Waited 10 to 15 minutes
- ☐ Pressed the red reset button on the bottom
- ☐ Turned the 1/4-inch hex key in the center hole until it spins freely
- ☐ Removed anything stuck with tongs, not hands
- ☐ Checked the breaker and GFCI outlet
- ☐ Tested with cold water running
How to Keep It From Happening Again
- Run cold water before, during and for about 15 seconds after grinding.
- Feed scraps in small handfuls instead of all at once.
- Keep grease, coffee grounds, pasta, rice, eggshells and stringy vegetables out.
- Do a quick check for silverware and bottle caps before you flip the switch.
This article is general home-maintenance information. Always cut power before working on any appliance, and call a licensed professional if you’re unsure or see signs of an electrical problem.
For a photo walkthrough of these same steps, Bob Vila’s garbage disposal troubleshooting guide is a good reference.
Small Fixes, Big Savings
A lot of household “emergencies” turn out to be a hidden button, a tripped breaker or a five-minute fix that nobody ever showed us. That’s the whole idea behind the Don’t Yet series: slow down, check the simple stuff, and avoid spending money you don’t have to. If this saved you a service call, take a look at the Don’t Yet books and grab a free checklist while you’re there.
Sources
- What to Do When Your Garbage Disposal Stops Working – Bob Vila
- Garbage Disposal Troubleshooting – HomeTips
Last reviewed: November 2026. Check your disposal’s manual for model-specific steps.

